Thursday, September 22, 2011

How do i successfully setup the timing on a 1993 2.2l accord after changing the timing belt?

i know the marks on the cam have to be at TDC and the crank pulley at TDC. there are also marks on the flywheel. the marks are tdc and a few inches past that is 3 red marks. do i need to set the cam at TDC and the crank at these red ignition marks for the timing to be correct? the engine is running but very poorly and dies often. i believe the timing is retarded. advice?How do i successfully setup the timing on a 1993 2.2l accord after changing the timing belt?Mark on cam pointed up and the two lines 180 degrees apart on cam gear must be line up parallel with top of cylinder head.Then mark on crankshaft at TDC,single mark on crank pulley line up with mark on oil pump housing.Check for everything lined up again after tensioner is in its position putting pressure on the belt.How do i successfully setup the timing on a 1993 2.2l accord after changing the timing belt?what carmen said + make sure you replace the balance shaft belt as well, the left hand shaft should have a mark to line it up and the other can be held in place with a metal rod (screwdriver) inserted on the firewall side of the engine.
  • software
  • How to make a baby quilt
  •